| Scat Manufacturing 2-440-6760-2374-1094A 6.760" Long Mopar Pro Sport 4340 Forged H-Beam Rods ARP 2000 7/16” Cap Screws 440 Big Block Rod Length: 6.760
Crank Pin: 2.374
Wrist Pin: 1.094
BE Width: 1.007
Bolts: ARP 2000 7/16” Cap Screws
With ARP 7/16” Cap Screws, The “Bad Boy” of all Scat Manufacturing Rods
available for serious horsepower engines.
• H-Beam design is the strongest Scat Manufacturing rod available
• Perfect for supercharged and nitrous applications
• Special doweled cap for specific cap-to-rod alignment Rod Torque Specs
1.) Disassemble rods and thoroughly clean (including bolt and beam threads) to remove rust preventative.
2.) Apply ARP Molylube to the threads and under the head of each bolt.
3.) Install rods by bringing cap and beam into alignment. Tap into place before installing bolts (DO NOT USE BOLTS TO PULL CAPS INTO POSITION) Each rod is numbered and MUST be assembled with the same number on cap and beam.
DESCRIPTION MAXIMUM RECOMMENDED TORQUE
5/16” x 1.500” ARP 2000 cap screw 26 ft./lb w/ARP moly
3/8” x 1.600” ARP 8740 cap screw 45 ft./lb w/ARP moly
3/8” x 1.600” ARP 2000 cap screw 50 ft./lb w/ARP moly
3/8” ARP 8740 Wave Loc bolt & nut 50 ft./lb w/ARP moly
7/16” x 1.400” ARP 8740 cap screw 64 ft./lb w/ARP moly
7/16” x 1.500” Scat Manufacturing 2000 cap screw 70 ft./lb w/ARP moly
7/16” x 1.600” ARP 8740 cap screw 63 ft./lb w/ARP moly
7/16” x 1.600” ARP 2000 cap screw 70 ft./lb w/ARP moly
7/16” x 1.800” ARP 8740 cap screw 63 ft./lb w/ARP moly
7/16” x 1.800” Scat Manufacturing 2000 cap screw 70 ft./lb w/ARP moly |
